Rinse bar edge to edge V Jet design

This Rinse bar fits all Edge 26cm brushes. Neatly tucked behind the brush. The 18 jet holes at 0.7mm are angled over the bristle, so there is less chance of damaging the bar. The end 4 jets on both sides are angled out horizontally so the water jets match the brush splay.

Key Features:

• Low profile design.
• Extremely lightweight.
• 18 jet holes at 0.7mm.
• Angle jets both vertically and horizontally.
• The height of the rinse bar can be adjusted.
• Quick-release water fitting.

Weight: 24g

Includes:  Two Stainless steel self-tapping screws.

Please note:

Drilling super-fine 0.7mm jet holes cleanly and efficiently is very challenging. We test these rinse bars during the drilling production setup; however, it is not feasible to test every rinse bar.  Like every other bar on the market, some jets might not flow straight. In our case, this is not due to a problem with the drilled hole but a problem with the drill swarf left behind. This can be easily solved by cleaning the hole with a 0.6mm pin.